16th May 2018 / Wk10
1. Trace the lines of pattern onto a sheet of metal
2. Cutting the edges to trim in to a shape
3. Compare the size of metal onto the laser cut pattern and allow extra 10mm on each ends for the metal to shrink.
4. Check both length and height and adjust to cut if needed.
6. Metal is beginning to shrink inside and repeat the process of shrinking and extending the metal to shape into its form.
9. Used wooden mallet to shape the forms by laying metal patten on to wooden pattern
10. Final assembly
1. Trace the lines of pattern onto a sheet of metal
2. Cutting the edges to trim in to a shape
3. Compare the size of metal onto the laser cut pattern and allow extra 10mm on each ends for the metal to shrink.
4. Check both length and height and adjust to cut if needed.
6. Metal is beginning to shrink inside and repeat the process of shrinking and extending the metal to shape into its form.
7. I trimmed the bottom edges to fit rightly along with other pieces
8. We assembled three pieces together
10. Final assembly
Comments
Post a Comment